Do you have a question about the Steren AMP-120 and is the answer not in the manual?
Total Harmonic Distortion (THD) | 0.1% |
---|---|
Input Impedance | 47 kOhms |
Frequency Response | 20 Hz - 20 kHz |
Power Source | AC 120V, 60Hz |
Output Impedance | 8 Ohms |
Power Output | 120 Watts RMS |
Signal to Noise Ratio | >85dB |
List of essential safety warnings for using the audio amplifier, covering usage, environment, and maintenance.
Controls for the siren switch and power status indicator.
Ports for connecting microphones and auxiliary audio sources, with gain controls.
Controls and display for the integrated MP3 player, including playback and mode functions.
Terminals for connecting speakers with various impedance options (COM, 4, 8, 16 Ohm) and line outputs.
Connections for DC power input, ground, and interlock cable.
Guide to connecting the amplifier to a 12V battery or an electrical outlet.
Diagrams illustrating different speaker wiring configurations: single, serial, parallel, and series/parallel.
Instructions for connecting microphones to the 6.3 mm input terminals.
Guide for connecting an audio player via the AUX input, noting adapter requirements.
Procedure for turning on the main switch and setting the initial gain levels.
Instructions for powering on the MP3 player and inserting SD or USB media for playback.
Steps to switch to Bluetooth mode and pair the device with a smartphone.
Steps for pairing a smartphone and switching between playback modes (memory or Bluetooth).
Using playback control buttons, EQ, and volume adjustments for the MP3 player.
Details on power input, frequency response, impedance, line output, and power output.
Information regarding the remote control's power input.
Terms and requirements for claiming warranty service, including proof of purchase and product condition.
Situations that will void the product warranty, such as accidental damage or improper use.
Contact details and addresses for retailers and the manufacturer for support and warranty inquiries.