2. SAFETY INSTRUCTIONS
To reduce the impact of noise and vibration emission, limit the operation
time, use low-vibration and low-noise operating modes and wear
personal protective equipment.
Take the following points into account to minimise the vibration and
noise exposure risks:
1. Only use the product as intended by its design and these instructions.
2. Ensure that the product is in good condition and well maintained.
3. Use the correct attachments for the product and ensure they are in
good condition.
4. Keep a tight grip of the handles/grip surface.
5. Maintain this product in accordance with these instructions and keep it
well lubricated (where appropriate).
6. Plan your work schedule to spread any high vibration tool use across a
longer period of time.
Vibration and noise reduction
Recommendation
The machine should be supplied via a residual current device (RCD) with a
tripping current of not more than 30 mA.
WARNING! When working with the cutter blade there is always
a risk of kickback if the cutting head comes into contact with
a hard object! Kickback will cause the sudden stalling of the cutting
head, which in turn results in the cutting head being forced in the
opposite direction to the rotation of the cutter blade! Ensure that you
retain a rm grip with both hands at any sign of such kickback, pay
attention and retain a rm stance to avoid injuries!”
274
EN
To Next Page
Loading...
