2. SAFETY INSTRUCTIONS
0
3
This product produces an electromagnetic eld during
operation! This eld may under some circumstances interfere
with active or passive medical implants! To reduce the risk of serious or
fatal injury, we recommend persons with medical implants to consult
their doctor and the medical implant manufacturer before operating
this product!
Before use, check that the cutter in good working order and that the
length of the blade is correct, as follows:
1. Ensure the switch is on the o position and disconnect the cable plug
from the mains supply.
2. Examine the general condition of the tool. Inspect the guard, switch,
and blade. Check for loose screws, misalignment, and binding of moving
parts, improper mounting, broken parts and any other condition that
may aect its safe operation. If abnormal noise or vibration occurs
during operation, turn the machine o immediately and have the
problem corrected .Do not use a damaged tool and attach a label “DO
NOT USE” to the tool.
3. Ensure that you are on a at surface and have secure footing.
Connect the cable to the power.
To switch on, pull the safety lock-o button forward and then keep the
switch trigger depressed.
To switch o, release the switch trigger.
WARNING! The tool runs for approximately 5 seconds after it has been
switched o. Let the motor came to a complete stand still before setting
the tool down.
Trimming
SWITCHING ON AND OFF
276
EN
To Next Page
Loading...
