288
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
BR
EN
4.3 FIRST USE
Check the battery : illustration
3.4
WARNING ! Read the « SAFETY INSTRUCTION » section at the
beginning of this manual including all text under subheading
therein before using this product.
The battery is not fully charged at the time of purchase.
Before using the product for the rst time, place the battery
in the charger and charge it fully.
Pay particular attention using the machine for the rst time : focus and dedicate all your attention to this
rst use. Make the rst trial on a free space with no obstacle and no surrounding element
4.4 OPERATION
Start the product : illustration
4.1
Press the lock-o button 1 and hold it in position.
Press the on/o switch 3 to switch the product on. Release the lock-o button 1 once the product is
running. Release the on/o switch 3 to switch the product o .
WARNING ! Never attempt to lock the on/o switch in its ON
position!
Warning! Switch o and remove the battery pack before any
adjustment
Length adjustment : illustration
4.4
Adjust the pole length to t your body height.
Loosen the locking sleeve 7 clockwise.
Pull the pole 8 out or push it together to adjust the desired length.
Tighten the locking sleeve 7 counter clockwise.
Adjusting the auxiliary handle : illustration
4.4
Loosen the knob and slide the auxiliary handle 11 up or downward to adjust the height to t the intended
application.Tighten the knob in the adjusted position. Ensure that the tooth system locks in place.
NOTE : Ensure the connection is properly secured. Tighten the knob so far until there is not gap between
the handle and handle support.
Angle adjustment : illustration
4.5
Adjust the trimmer head to either 0° for trimming or 180° for edging.
Slide the unlock sleeve 6 upward and turn the main handle 2 clockwise while holding pole 8 to adjust the
trimmer head to an angle of 180°. Ensure the unlock sleeve 6 snaps into place.
To Next Page
Loading...
