STERWINS A061003 - Operation; Setting up your tiller; Wheel adjustment; Installing;Removing extension cord

Risk of death by electrocution or electric shock or serious personal
injury if power lines or electric cords are contacted. Never operate
tiller over electrical sources, cords, or wires.
6. OPERATION
DANGER! Risk of injury due to electric shock.
Warning! Do not plug in before installation is fully completed!
Set up the tiller on at and rm ground to ensure safe and sturdy operating.
Insert the lower handle
15
into the handle xing hole of the tiller and tighten it with the knob
5
.
Fix the upper
7
and lower handles
15
with the knob
5
.
Fasten the power cord
4
to the handle with two cordclips
6
.
Setting up your tiller
Wheel adjustment
Installing/Removing extension cord
The wheels can be adjusted to
3
positions.
Pull on the wheel
14
and move to required position, let go of the wheel and make sure it locks
in position.
When shipped,the wheels on the tiller are set to a transport position.
The other two are working position.The higher the wheel, the deeper the eld.
Connect to power supply when you are ready to use the tiller.
Insert the female end of the extension cord into the product.
Connect the male end of the extension cord to the power source.
Make sure the extension cord is secured before beginning operation.
268
FR
ES
PT
IT
EL
PL
RU
EN
KZ
UA
RO