OPERATION SAFETY WARNING
WARNING! This product has not been designed to provide
protection from electric shock in the event of contact with
overhead electric lines! Therefore do not use product near cable,
electric power or telephone lines. Keep a minimum distance of
10 m to all electric lines.
- File position
- Diameter of round le
- File depth
3. To sharpen the chain proceed as follows:
• Use protective gloves.
• Ensure the chain is correctly tensioned.
•
Engage the chain brake to lock the chain on the bar.
4. Use a chain le, whose diameter is 1.1 times the cutting tooth depth.
Make sure 20 % of the le diameter is above the cutter’s top plate.
5. File at an angle perpendicular to the bar, and at an angle of 25° to the
direction of travel.
6. File each tooth from the inside towards outside only. File one side of
the chain rst than turn the saw around and repeat the process.
7. Sharpen each tooth equally by using the same number of strokes.
8. Keep all cutter lengths equal. Check the safety depth gauge height
every 5 sharpenings. If the depth gauges are also trimmed it is
essential that the original prole be restored.
9. Use a depth gauge measuring instrument to check the height of the
depth gauge. Depth gauge measuring jigs are available from most
reputable tool merchants .
2. SAFETY INSTRUCTIONS
43
EN
To Next Page
Loading...