37
Oil´s filter
(b) Unassemble the filter and clean it with fuel or replace it with a new one if necessary.
Note:
•
After removing the filter, use a clamp to hold the end of the suction tube.
•
When assembling the filter, be careful of dust do not fall inside the suction tube..
3. Oil tank
With a wire hook remove the filter through the oil
tank and clean it with fuel. When placing the filter
back to the tank, make sure it reaches the right
front corner. It also prevents the dirt in the tank.
4. Spark Plug
Clean the electrodes with a wire brush and adjust the separation to
0,65mm if necessary.
5. Pinion
Verify the cracks and the wearing down of the pinion that can
interfere in the chain operation. If the wearing down is considerable,
replace it with a new one. Do not fit a new chain on a worn away
pinion, or a chain worn away on a new pinion.
To Next Page
Loading...
