Need help?Do you have a question about the StetSom EX3000 and is the answer not in the manual?
Connect RCA cables for signal input and adjust signal level.
Configure High Pass and Low Pass filters for frequency reproduction.
Control bass, frequency, mid-bass, and mid-high boost levels.
Disables Crossover and Boost controls for a flat audio response.
Amplifier cooling vents require unobstructed airflow.
MONO output for speaker connection; verify impedance and polarity.
Connect positive/negative terminals to battery via 4 AWG cable and fuse.
Connect REM terminal for automatic amplifier activation by the radio.
Describes the function of POWER, PROT, and CLIP LEDs.
Explains troubleshooting based on PROT LED flash count for specific issues.
Specifies correct cable gauges for power, remote, and speakers.
Advises professional installation with the unit powered off.
Addresses amplifier not turning on, no sound, and lack of bass.
Explains PROT LED flashing and how to resolve sound distortions.
Guides on resolving noise by checking wiring, power, and grounding.
Details RMS power output at different impedances and supply voltages.
Lists input sensitivity, signal-to-noise ratio, and frequency response.
Provides specifications for crossover filters and bass boost ranges.
Lists power consumption, supply voltage, dimensions, and weight.
Details the one-year warranty against manufacturing defects.
Lists conditions that invalidate the product warranty.
Provides contact channels for customer service and product advice.
General| Brand | StetSom |
|---|---|
| Model | EX3000 |
| Category | Camera Accessories |
| Language | English |
To Next Page