Need help?Do you have a question about the StetSom XOVER STX84 and is the answer not in the manual?
General introduction to Stetsom electronic crossovers, highlighting performance and fidelity.
Crucial pre-installation steps and recommendations for optimal performance and safety.
Details on RCA inputs and mode selection for front, sub/rear channels.
Explanation of the ON/OFF switch, LEVEL adjustment, and RCA output for the FLAT way.
Details on Subsonic Filter, Bass Boost, Low Pass, Phase, ON/OFF, LEVEL, and RCA output.
Explanation of High Pass, Low Pass, ON/OFF, LEVEL, and RCA output for the MID way.
Details on Phase, High Pass, ON/OFF, LEVEL, and RCA output for the HIGH way.
Description of the LED indicator's function when the device is activated.
Details on phase inversion, stereo/mono modes, and RCA inputs for various channels.
Explanation of the ON/OFF switch, LEVEL adjustment, and RCA output for the FLAT way.
Details on Subsonic Filter, Bass Boost, Low Pass, Phase, ON/OFF, LEVEL, and RCA output.
Explanation of High Pass, Low Pass, ON/OFF, LEVEL, and RCA output for the MID LOW way.
Details on High Pass, Low Pass, ON/OFF, LEVEL, and RCA output for the MID HIGH way.
Explanation of Phase, High Pass, ON/OFF, LEVEL, and RCA output for the HIGH way.
Description of the LED indicator's function when the device is activated.
Recommended cable gauges for power and remote connectors for proper installation.
Mandatory fuse/circuit breaker use and requirement for qualified professional installation.
Steps to diagnose and resolve issues where the amplifier does not power on.
Steps to diagnose and resolve issues related to the absence of sound output.
Guidance on identifying and eliminating noise or interference in the audio signal.
Details on the warranty period, start date, and required documents for claims.
Specific conditions and actions that will invalidate the product's warranty.
Information on how to contact Stetsom for questions, advice, and technical assistance.
General| Channels | 4 |
|---|---|
| Input Impedance | 10k Ohms |
| Signal-to-Noise Ratio | >90dB |
| THD | <0.01% |
| Frequency Response | 10Hz - 30kHz |
| Crossover Type | Linkwitz-Riley |
| Maximum Output Voltage | 8 V |
| Bass Boost | 0 a +12dB |
| Power Supply Voltage | 10V - 15V DC |
To Next Page