STI Magnetrol Kotron 811 - User Manual

Installation and Operating Manual
RF
Capacitance
Level
Measurement
Kotron
®
Model 811
RF Point Level Sensor

Summary

Safety Messages

Electrostatic Discharge (ESD) Handling

1.0 Complete Installation

1.2 Electrostatic Discharge (ESD) Handling Procedure

Recommended steps to reduce risk of component failure due to static electricity.

1.4 Mounting

1.4.1 Horizontal Mounting

1.4.2 Vertical Mounting

1.5 Probe Installation

1.5.1 Installing a Guarded Probe

Steps for threading and securing a guarded probe assembly.

1.5.2 Installing a Standard Probe

Procedures for installing a standard probe, including checks and tightening.

1.5.3 Installing a Flexible Probe

1.6 Installing a Remote Mount Unit

1.6.1 Remote Mount with Guarded Probe

Installation procedures for remote mount units with guarded probes.

1.6.1.1 Electronic Housing

Location and mounting of the remote electronic housing for guarded probes.

1.6.2 Remote Mount with Rigid and Flexible Probes

Installation procedures for remote mount units with rigid and flexible probes.

1.6.2.1 Electronic Housing

Location and mounting of the remote electronic housing for rigid/flexible probes.

1.6 Probe Housing Connections

1.6.1.2 Probe Housing Connections

1.6.2.2 Probe Housing Connections

1.7 Wiring

1.7.1 Probe Wiring

Connecting probe wires to the amplifier enclosure and ground screw.

1.7.2 Electrical Wiring

1.7.3 Operating Mode Selection

1.8 Calibration - Narrow Differential

1.8.1 Set Point Adjustment Alarm

Procedure for setting the alarm point using dip switches and potentiometers.

1.8.2 Low Level Alarm

1.8.3 Low Level Alarm

1.8.4 High Level Alarm

1.8.5 High Level Alarm

1.8.6 Time Delay

1.9 Calibration-Wide Differential

1.9.1 Set Point Adjustment Control

Adjusting set point using dip switches and potentiometers for wide differential calibration.

11. Differential control

1.9.2 Time Delay

2.3 Troubleshooting

No Signal with Level Change

Steps to check wiring, switches, calibration, and ground reference.

Probe Issues

Procedure to check for malfunctioning sensing probes using an ohmmeter.

2.3.3 Switch Chatter

2.4 Agency Approvals

2.4.1 Agency Specifications - Intrinsically Safe Installation

2.4.2 Agency Specifications - Explosion Proof Installation

2.6 Specifications

2.6.1 Functional

2.6.2 Physical

STI Magnetrol Kotron 811 Specifications