INSTALLATION
Alternative installation options
28 | DHB STi www.stiebel-eltron.com
13.11 Pivoting appliance cover
The appliance cover can be rotated for undersink installation.
26�02�02�0865
Remove the programming unit from the appliance cover by
undoing the screws.
Turn the appliance cover (not the appliance) and refit the
programming unit.
Plug the set value transducer cable into the PCB (see chapter
"Installation/ Commissioning/ Initial start-up").
Hook the appliance cover in at the top. Swivel the appliance
cover down onto the back panel and press it until it engages
audibly.
Secure the appliance cover.
To Next Page
Loading...
