10. Installation
Standard installation
- Electrical connection from below on unfinished walls
- Water connection on unfinished walls
For further installation options, see chapter "Installation/
Installation options":
- Electrical connection from above on unfinished walls
- Electrical connection on finished walls
- Large conductor cross-section for electrical connection from
below
- Connecting a load shedding relay
- Water installation on finished walls
- Water installation on finished walls with brazing/ compres-
sion fitting
- Water installation on finished walls; fitting the appliance
cover
- Installation of lower back panel with threaded fittings on fin-
ished walls
- Wall mounting bracket when replacing an appliance
- Installation with offset tiles
- Pivoting appliance cover
10.1 Standard installation
Opening the appliance
26�02�02�0864
Open the appliance by pulling the flap downwards, undo the
screw and lift up the appliance cover.
26�02�02�1101
Remove the back panel by pressing the two locking hooks
and pulling the lower section of the back panel forwards.
Preparing the power cable
30
1
26�02�02�0824�
1 Installation aid
Prepare the power cable.
Fitting the wall mounting bracket
26�02�02�0810�
Mark out the holes for drilling using the installation plate.
If the appliance is to be installed with water connections on
finished walls, also mark out a fixing hole in the lower part
of the template.
Drill the holes and secure the wall mounting bracket with
2screws and 2rawl plugs (screws and rawl plugs are not
part of the standard delivery).
Fit the wall mounting bracket.
Making the water connection
!
Material losses
Carry out all water connection and installation work in
accordance with regulations.
12
D0000053319
Seal and insert the twin connectors.
To Next Page
Loading...
