6
Room temperature
With parameter ROOM TEMP 1 or 2, you can
adjust the Set room temperature for the day
and setback mode of heating circuit 1 or 2.
Changing these parameters results in a parallel
offset of the heating curve.
The actual room temperature can also be
scanned, as soon as the FE 7 remote control
has been connected and allocated to heating
circuit 1 or 2.
DHW temperature
With parameter DHW TEMP, you can allocate
a set day and night temperature to the
temperature inside the DHW cylinder.
Open the control flap.
Open the control flap.
Ventilation
With parameter VENTILATION, you can adjust
the operating modes for ventilation operation.
When the required operating mode is shown,
press PRG; the operating mode is then set.
In addition, the display will be reset by turn-
ing the rotary selector to Filter reset and
subsequent pressing of PRG as well as setting
to ON followed by repeatedly pressing PRG.
Open the control flap.
Settings at control level 2 for users and contractors
Standby
or
Filter reset
ROOM T HC1
SET ROOM T DAY
SET ROOM T DAY
SET ROOM T NGT
SET ROOM T NGT
ACTUAL ROOM T
BACK
ROOM T HC1
DHW TEMP
SET DHW T DAY
SET DHW T DAY
SET DHW T NGT
SET DHW T NGT
ACTUAL DHW T
DHW TEMP
BACK
To Next Page
Loading...
