7
Time and date
With parameter TIME/DATE, you can adjust the
time and the Summer time.
At the factory, summer time is set to begin on
the 25 March and to end on the 25 October.
Open the control flap.
Setting the time
or
Summer time
Holiday and party program
The holiday program controls heating, DHW
and ventilation functions. When the outside
temperature is above +4 °C, heating and DHW
functions are switched off. Below
+4 °C, the DHW cylinder is held at 40 °C and
the heating circuit temperature is held at a
setback temperature of +15 °C.
Before DHW heating, the heat pump runs in
heating mode for approx. 2 minutes.
Ventilation runs in setback mode.
Holiday mode is shown on the display with
the flap closed. For the start of the holidays,
the year, month and day are entered; also
enter the year, month and day for the end
of the holidays. The start and end time is
always 24:00 h of the date entered. After the
holiday period has expired, the heat pump
system operates again in accordance with the
previous heating and DHW program.
In Party mode, you can extend the day mode
for central heating by a few hours. This is
displayed with the flap closed.
For example, if the heating program normally
switches to setback mode at 22:00 h, and you
set the party mode to two hours, then setback
mode would only begin at
24:00 h.
PRG
PRG
PRG
PRG
PRG
PRG
PRG
PRG
PRG
Open the control flap.
PRG
PRG
PRG
PRG
PRG
PRG
PRG
PRG
PRG
TIME / DATE
SET CLOCK
TIME
TIME
YEAR
MONTH
DAY
SET CLOCK
BACK
TIME / DATE
HOL/PARTY
HOLIDAY
YEAR START
MONTH START
DAY START
YEAR STOP
MONTH STOP
DAY STOP
HOLIDAY
BACK
HOL / PARTY
To Next Page
Loading...
