EN
means the battery is good. If not,
the battery needs to be changed.
CHECKING THE CHARGER
If the battery pack does
not charge properly:
• Check the current at the
power outlet with another
tool. Make sure that the
outlet is not turned o.
• Check that the charger
contacts have not been shorted
by debris or foreign material.
• If the surrounding air
temperature is not normal
room temperature, move the
charger and battery pack to a
location where the temperature
is between 7 ˚C and 40˚C .
If the battery is inserted
into the charger when warm
or hot, the CHARGING LED
indicator light on the charger
may switch on and illuminate
ORANGE. If this occurs
allow the battery to cool
outside of the charger from
approximately 30 minutes.
CHARGER MOUNTING
• This charger can be installed
hanging on a wall using two
screws (not supplied).
• Locate the placement for the
charger to be wall mounted.
• If fastening to wood studs
use 2 wood screws.
• Drill two holes 2 3/8” (6 cm) on
center ensuring they are level.
• If fastening to drywall use
wall anchors and screws to
secure the charger to the wall.
NOTE If the battery and the
charger won’t be used for a
long time, please remove the
battery from the charger and
pull out the AC power plug.
IMPORTANT SAFETY INSTRUCTIONS
• SAVE THESE
INSTRUCTIONS - DANGER:
TO REDUCE RISK OF FIRE
OR ELECTRIC SHOCK
CAREFULLY FOLLOW
THESE INSTRUCTIONS.
• Conrm the voltage available
at each country location
before using the charger..
6. CLEANING
To avoid risk of fire, electric
shock, or electrocution:
To Next Page
Loading...
Need help?
General
