EN - 5
ce for moving the machine and its packaging, always
making use of suitable equipment. Do not use the ma-
chine until all the instructions provided in the “ASSEM-
BLY” section have been carried out.
4.1 ASSEMBLY COMPONENTS
4.1.1 Unpacking
1.
2.
including these instructions.
3.
4.
5.
4.2
• Type "I"
• Type "II"
4.3 HANDLE ASSEMBLY
• Type “I”, Type “II”
1.
2.
3.
4.
height of the handle to the operator's stature.
5.
5. CONTROLS
5.1 CONTROL LEVER
Run.
Stop.
Ignition of the motor simultaneously
engages the cutting means.
5.2
Do this when the cutting means is stationary.
1.
2.
of the grooves on the inside of the chassis.
3.
Do not tilt the wheel axle during this operation,
so that it slots simultaneously into one of the grooves
provided.
A. Ground position. The cutting height
B. Intermediate position. The cutting height
C. High position. The cutting height is
6. USING THE MACHINE
The safety regulations to follow are described in
chap. 2. Strictly comply with these instructions to avoid
serious risks or dangers.
6.1 PREPARATION
horizontal position on the ground.
6.1.1
a.
grass catcher:
1.
-
6.1.2
To Next Page
Loading...
