Need help?Do you have a question about the Stiga MULTICLIP 46 SE and is the answer not in the manual?
General| Cutting Width | 46 cm |
|---|---|
| Engine | Stiga |
| Net Power | 1.8 kW |
| Drive | Self-propelled |
| Cutting Height Range | 25 - 75 mm |
| Cutting Height Adjustment | Centralized |
| Handlebar | Ergonomic, adjustable |
| Vibration Level | 2.5 m/s² |
| Guaranteed Sound Level | 96 dB(A) |
| Motor Type | 4-stroke |
| Power Source | Petrol |
| Engine Displacement | 125 cc |
| Starter | Recoil |
| Wheels | Front: 180 mm, Rear: 240 mm |
Explains symbols for warnings, reading instructions, keeping onlookers away, and safety precautions.
Instructions for folding the handle and selecting one of four mowing positions.
Secure wires and electric cable in holders; attach starter handle to the right side.
Warning about toxic electrolyte. Charge battery for 24 hours before first use.
Fill crankcase with oil and check oil level before starting the engine for the first time.
Instructions on refueling safely, avoiding hot engines, and fuel type recommendations.
Steps for starting Briggs & Stratton and Honda engines, including primer and throttle control.
How to engage and disengage the drive system by pressing the clutch loop.
Release the start/stop loop to stop the engine. Disconnect spark plug cable for safety.
Prepare lawn, use high speed, avoid cutting too short, keep deck clean for best results.
Adjust cutting height on front wheels and vary rear axle positions for desired cut.
Clean the mower, especially the underside, with a hose. Avoid high-pressure washers.
Clean cylinder cooling flanges and air intake of grass and dirt before each use.
Lubricate the drive shaft at glide bearings at least once per season.
Change oil after 5 hours, then every 50 hours or season. Use specified oil type and quantity.
Clean or replace air filter regularly to maintain engine performance and prevent wear.
Clean spark plug, check gap, and replace if damaged. Follow engine manufacturer recommendations.
Ensure battery is charged. Connect charger to battery terminal, not engine terminal.
Adjust clutch cable if drive engagement is poor or mower is slow.
Use protective gloves. Replace blunt blades. Tighten blade screw to 40 Nm.
Sharpen blades by wet grinding and balance them to prevent vibration damage.
Empty fuel tank, add oil to cylinder, clean, and store indoors in a dry, cool place.
Genuine spare parts are available from service workshops and dealers. Check STIGA website.
To Next Page