Need help?Do you have a question about the Stiga MULTICLIP 51S and is the answer not in the manual?
General| Cutting Width | 51 cm |
|---|---|
| Drive Type | Self-propelled |
| Vibration Level | 2.5 m/s² |
| Power Source | Petrol |
| Cutting Height Adjustment | Centralized |
| Cutting Method | Mulching |
| Handlebar | Adjustable, ergonomic |
Explains safety symbols like 'Read Manual', 'Keep Spectators Away', 'Keep Hands/Feet Away', 'Remove Spark Plug'.
Certain sections apply only to specific models; some models lack a throttle.
Fold back and screw tight the lower part of the handle using screws A.
Fit the upper part of the handlebar; height is adjustable via slotted holes.
Fit the wire bracket using the nut and bolt provided.
Attach cables (Start/Stop, Clutch) to the cable bearers D and E.
Fill crankcase with oil and check oil level before initial motor start.
Fill engine crankcase with 0.6 litres of oil (SAE 30/10W-30) up to the "FULL/MAX" mark.
Ensure oil level is between "FULL/MAX" and ADD/MIN" on dipstick; mower must stand level.
Fill with unleaded petrol; never when hot or running. Allow room for expansion.
Steps for starting Briggs & Stratton engines include primer, start/stop loop, and starter operation.
Steps for starting Honda engines involve petrol tap, choke, start/stop loop, and starter handle.
Engage/disengage drive using coupling clamp I. Lift handle to maneuver.
Engage drive with clutch control M. Lift handle to maneuver.
Release Start/Stop loop G. For Honda, close petrol tap.
Best results require removing stones, high speed, proper cut length, cleanliness, sharp blade, and avoiding wet grass.
Shut off motor before adjusting. Set height to avoid hitting uneven ground.
Service only after switching off motor and removing spark plug cable.
Clean cylinder cooling flanges and air inlet before use for proper cooling.
Clean mower after each use, especially underside. Avoid high pressure washers.
Change oil when warm and tank empty. First after 5 hrs, then every 50 hrs or season.
Clean/replace air filter regularly to maintain engine output. Specifics for Briggs & Stratton and Honda.
Electrolyte is toxic. Charge battery if engine won't start. Do not connect charger to engine terminal.
Store battery charged in dry/cool place (0-15°C). Recharge periodically during storage.
Clean regularly with wire brush. Change if worn. Check gap (e.g., 0.76mm for B&S).
Adjust cable if drive doesn't engage or mower is slow. Ensure mower can be pushed freely when disengaged.
Control clutch function. Ensure spring H extends 6mm when engaged. Adjust nipple I.
Check belt tension. Adjust screw L to center shoulder bolt K in engine bracket hole.
Check shock-absorber twice per season for damage or wear.
Use protective gloves. Replace blunt/damaged blades. Fit new blade with STIGA logotype facing attachment. Torque to 40 Nm.
Sharpen using wet method grinding (whetstone/grindstone). Balance after sharpening to avoid vibration.
Empty fuel tank, run engine dry. Add oil to cylinder, screw plug back in. Store indoors in a dry place.
To Next Page