Need help?Do you have a question about the Stiga PRO 48 and is the answer not in the manual?
General| Brand | Stiga |
|---|---|
| Model | PRO 48 |
| Category | Lawn Mower |
| Language | English |
Install the handle/bumper on the PRO 51 S model by securing it with bolts and nuts.
Attach the lower part of the handle by folding it back and screwing it in place.
Fit the upper part of the handlebar, noting its height adjustability and pivoting capability.
Secure the cables, distinguishing between start/stop, throttle, and clutch cables.
Prepare the mower before starting, including filling the crankcase with oil and checking the oil level.
Fill the engine crankcase with the specified type and amount of oil before initial use.
Verify the engine oil level is between the 'FULL/MAX' and 'ADD/MIN' marks.
Fill the petrol tank with appropriate fuel before starting, allowing room for expansion.
Steps to start the engine for Briggs & Stratton models, including primer and start/stop loop.
Steps to start the engine for Honda models, including fuel tap, throttle, and start/stop loop.
Engage and disengage the drive for Multiclip 51S models using the clutch loop.
Release the Start/Stop loop to stop the engine; do not lock it in place.
Remove the spark plug cable when leaving the mower unattended for safety.
Always switch off the engine and remove the spark plug cable before any servicing.
Stop the engine and remove the spark plug cable before lifting the mower.
Tilt the mower with the spark plug facing upwards and ensure the fuel tank is empty.
Clean the engine's cooling system, specifically the cooling flanges and air intake.
Clean the mower, especially the underside, and avoid high-pressure washers.
Regularly clean the silencer area to remove grass, dirt, and flammable waste.
Clean under the transmission casing for Multiclip 51S/PRO 51S models periodically.
To Next Page
