Need help?Do you have a question about the Stiga SILENT and is the answer not in the manual?
General| Brand | Stiga |
|---|---|
| Model | SILENT |
| Category | Lawn Mower |
| Language | English |
Connect to an earthed, single-phase electric socket protected by a 10A fuse. Use outdoor extension leads.
Press block button, then starter grip. Release starter grip to stop. Ensure safety.
Integrated overload protector may trip. Let motor cool for 2 minutes before restarting.
Connect drive by pressing clutch lever. Disconnect by releasing lever.
Route cable behind, avoid wet grass, keep blade sharp, empty collector.
Use single lever control. Do not set too low. Disconnect plug before adjustment.
Clean air intake for cooling. Clean chassis underside. Do not use water.
Adjust cable if mower does not move with clutch lever pressed.
Replace blunt or damaged blades. Use protective gloves and tighten bolt to 20 Nm.
Sharpen with wet method grinding. Balance blade after sharpening to avoid vibration.
Clean the mower thoroughly and store indoors in a dry place.
Fold up handle. Screw lower part into sockets for height adjustment. Tighten locking knobs.
Assemble grass collector and place in ejector opening. Can be used without collector.
To Next Page
