Need help?Do you have a question about the Stiga TORNADO 51 S and is the answer not in the manual?
General| Engine Type | 4-stroke |
|---|---|
| Cutting Width | 51 cm |
| Cutting Height Adjustment | Centralized |
| Cutting Height Range | 25 - 75 mm |
| Grass Collector | 55 L |
| Drive Type | Self-propelled |
| Engine | STIGA |
| Engine Displacement | 123 cm³ |
| Wheels | 200 / 280 mm |
Fill the engine crankcase with 0.6 liters of good quality oil before first use.
Check oil level before each use; ensure it is between the 'FULL' and 'ADD' marks on the dipstick.
Do not refuel with a hot or running engine. Leave expansion space in the tank.
Keep hands/feet away from rotating blades. Start on firm, level ground.
Engage drive by pushing coupling lever towards handle. Disengage by releasing lever.
Release the Start/Stop lever to stop the engine. Disconnect spark plug cable for safety.
Stop engine before adjusting cutting height. Adjust to 1 of 8 positions using the single lever.
Clean the mower after each cut, especially the underside of the cutting deck. Do not use a pressure washer.
Clean the engine's cooling fins and air intake of debris before each use.
Lubricate plastic bushings/friction bearings of the drive shaft at least once per season.
Change oil when the engine is hot and fuel tank is empty. First change after 5 hours, then every 50 hours.
Clean the air filter every 25 hours or three months. Clean foam filter with detergent and water, then oil it.
Clean spark plug regularly. Adjust electrode gap to 0.7-0.8 mm. Use Champion J19LM or equivalent.
Adjust clutch cable if engaging/disengaging is difficult. Adjust nipple until machine can be pushed backward.
Wear gloves when changing blades. Ensure correct installation and tighten to 40 Nm.
Sharpen blades wet. Balance after sharpening to prevent vibration damage.
Empty fuel tank. Run engine dry. Oil cylinder. Clean and store indoors.
Original spare parts are available from repair shops and other establishments.
To Next Page
