BT 45
English
11
spark arrester. Other states or
governmental entities/agencies, such as
the U.S. Forest Service, may have
similar requirements. Contact your local
fire agency or forest service for the laws
or regulations relating to fire protection
requirements.
Tighten all nuts, bolts and screws except
the carburetor adjustment screws after
each use.
For any maintenance of the emission
control system please refer to the
maintenance chart and to the limited
warranty statement near the end of the
instruction manual.
Do not clean your machine with a
pressure washer. The solid jet of water
may damage parts of the machine.
Store your power tool in a dry and locked
location out of reach of children. Before
storing for longer than a few days,
always empty the fuel tank (see chapter
"Storing the Machine" in the instruction
manual).
Assist handle for wood drill
Before mounting a new assist handle for
the first time:
N Hold the handle (1) by the clamp
and turn it clockwise until the
gap (2) is completely closed.
This breaks the small plastic retainer in
the clamp and allows the clamp to be
opened up.
Normal mounting procedure
N Hold the clamp firmly and unscrew
the handle counterclockwise.
N Open up the clamp slightly.
N Push the handle over the chuck until
it butts against the machine – the
clamp must engage the groove on
the gearbox housing.
N Screw the handle into clamp
clockwise.
N Move the handle to the required
position and tighten it down firmly.
Mounting the Handles
To Next Page
Loading...