BT 45
English
16
N To correct a misalignment, turn the
cap (with the grip up) until it drops
fully into the tank opening.
N Twist the cap counterclockwise as
far as it will go (approx. 1/4 turn) –
this will twist the base of the cap into
the correct position.
N Twist the cap clockwise, closing it
normally – see the sections
"Closing" and "Checking for proper
closure."
N If your cap still does not tighten
properly, it may be damaged or
broken; immediately stop use of the
unit and take it to your authorized
STIHL dealer for repair.
The power drill is equipped with a
change-speed gearbox. Depending on
the application and the drilling tool used,
the speed can be adjusted to suit
requirements.
Knob positions
The position of the rotary knob may be
changed only when the engine is
running at idle speed – the drilling
spindle must be stationary. It may be
necessary to turn the drilling spindle
slightly before the rotary knob can be
moved to the required position.
Do not change the position of the rotary
knob while the engine is running above
idle speed – the drilling tool rotates.
N (Neutral)
– Gearbox idle position for starting the
engine
– For adjusting the carburetor
– For changing drilling tools
1
– Low-speed clockwise rotation, see
"Specifications"
2
– High-speed clockwise rotation, see
"Specifications"
R
– Counterclockwise rotation, e.g. for
releasing a trapped drilling tool
Gearbox
To Next Page
Loading...