BT 45
English
25
The bits of broken spring may still be
under tension and could fly apart when
you remove the rope rotor. To reduce
risk of injury, wear eye and face
protection and work gloves.
N Place the new spring with frame in
position – check that outer loop (6)
is properly engaged.
N Use a suitable tool to push the
spring into the housing. Apply tool
through the openings (arrows). The
frame slips off in this process.
If the spring pops out and uncoils, refit it
in the counterclockwise direction,
starting outside and working inwards.
N Refit the rope rotor as described in
"Replacing the Starter Rope".
N Tensioning the rewind spring
N Fit the fan housing.
For periods of 3 months or longer
N Remove the drilling tool.
N Drain and clean the fuel tank in a
well ventilated area.
N Dispose of fuel properly in
accordance with local
environmental requirements.
N Run the engine until the carburetor
is dry – this helps prevent the
carburetor diaphragms sticking
together.
N Thoroughly clean the machine – pay
special attention to the cylinder fins
and air filter.
N Store the machine in a dry, high or
locked location, out of the reach of
children and other unauthorized
persons.
Storing the Machine
To Next Page
Loading...