Stihl FC 56 C User Manual

FC 56 C
English
13
Adjust correctly
The depth of cut depends on the
uneveness of the ground, your height
and the way you hold the edger. Use the
following procedure:
N Adjust the depth wheel (2) so that
the blade (3) just touches the
ground or breaks the surface of the
soil by no more than 0.2 in
(5 mm) (B) in the normal working
position.
N Tighten down the wingnut
clockwise.
N Standing in the normal working
position, check the depth of cut
again and correct it if necessary,
The deflector has been set at the factory
so that the arrow on the deflector and
the open side point away from the
operator. This ensures that cuttings and
other debris are directed away from the
machine and operator.
Lawn edging
N Starting the engine
N Start the cut at no less than half
throttle and continue cutting at full
throttle.
N Hold and guide your edger so that
the blade is vertical.
N Cut steadily so that the engine is not
lugged down – do not apply force.
N Cut at no more than a normal
walking pace.
N Do not push the blade into the
ground.
N Always walk forwards when cutting,
do not pull the unit towards you.
N Edge at a steady pace to avoid
having to make several passes.
B
241BA002 KN
2
3
Do not adjust the deflector.
241BA003 KN
0815BA004 KN
241BA004 KN
90°

Stihl FC 56 C Specifications

General

Brand	Stihl
Model	FC 56 C
Category	Lawn Mower
Language	English