Stihl FC 70 - Starting; Stopping the Engine

FC 70 C
English
20
N If your fuel cap still does not tighten
properly, it may be damaged or
broken. Stop using the power tool
and take it to your authorized STIHL
dealer for repair or replacement.
Controls
1 Throttle trigger lockout
2 Throttle trigger
3 Stop switch with Run and 0 = Stop
positions.
Function of stop switch and ignition
system
The stop switch is normally in the Run
position, i.e. when it is not depressed:
The ignition is switched on – the engine
is ready to start. If the stop switch is
moved to the 0 position, the ignition is
switched off. The ignition is switched on
again automatically after the engine
stops.
Starting the Engine
N Press the manual fuel pump
bulb (4) at least five times – even if
the bulb is already filled with fuel.
Cold engine (cold start)
N Press in the choke knob (5) and turn
it to g at the same time.
Warm engine (warm start)
N Press in the choke knob (5) and turn
it to < at the same time.
Starting / Stopping the
Engine
3
0815BA001 KN
1
2
4
547BA015 KN
5
547BA016 KN
5
547BA017 KN