FS 110, FS 110 R
English
28
(3) may point in either direction. The
cutting edges of (2), (4) and (5) must
point clockwise.
Direction of rotation is indicated by an
arrow on the inside of the mowing
attachment deflector or limit stop.
N Place the cutting attachment (6) on
the thrust plate (7).
Collar (see arrow) must engage the
mowing head's mounting hole.
N Fit the thrust washer (8) and rider
plate (9) on the shaft (10).
N Block the drive shaft.
N Use the combination wrench (12) to
screw the mounting nut (11) on to
the output shaft counterclockwise
and tighten it down firmly.
If the mounting nut turns too freely, fit a
new one.
Removing the metal cutting attachment
N Block the drive shaft.
N Unscrew the mounting nut
clockwise.
N Take the parts off the shaft – do not
remove the thrust plate (7).
The STIHL 4-MIX engine features
mixture lubrication and must be run on a
fuel mixture of gasoline and engine oil.
It operates otherwise on the 4-stroke
principle.
4-MIX Engine
To Next Page
Loading...
