To Next Page
A
Angel DavenportSep 7, 2025
How to fix ball bearing of the clutch drum is damaged on Stihl Brush Cutter?
- LLevi DelgadoSep 8, 2025
Replace ball bearing.
How to fix ball bearing of the clutch drum is damaged on Stihl Brush Cutter?
Replace ball bearing.
What to do if my Stihl Brush Cutter engine runs rough and misfires?
If your Stihl Brush Cutter engine runs roughly, misfires, or experiences temporary power loss, the spark plug boot may be loose. Press the boot firmly onto the spark plug and fit a new spring if necessary.
Why won't the starter rope rewind on my Stihl Brush Cutter?
If the starter rope does not rewind, heavy fouling or rust may be present on the rewind spring. Clean or replace the rewind spring.
What to do if irregular spark on Stihl Brush Cutter?
Check proper functioning of lever for stop function/contact spring or slide control/microswitch and ignition module. If there is damaged insulation or interruption in the ignition lead or a short circuit wire, check the ignition lead/ignition module, and replace the ignition module if necessary. Check operation of spark plug, clean spark plug and replace if necessary. For versions with M-Tronic, carry out diagnosis.
How to fix pinion damaged or worn on Stihl Brush Cutter?
Replace set of pinions on the drive side and non-drive side.
What to do if cutting attachment out of true on Stihl Brush Cutter?
Resharpen cutting attachment, replace if necessary.
What to do if screws of the clutch are loose on Stihl Brush Cutter?
Tighten the screws. Replace the clutch if necessary and check the threaded holes on the flywheel, replacing the flywheel if needed.
How to fix broken tension springs of the clutch shoes on Stihl Brush Cutter?
Replace tension springs.
What to do if metering diaphragm damaged or shrunk on Stihl Brush Cutter?
Replace metering diaphragm.
Why does the drive tube assembly on my Stihl Brush Cutter get very warm?
If the drive tube assembly becomes very warm, the drive shaft may not be sufficiently lubricated. Lubricate the drive shaft along its entire length, ensuring the entire length of the flexible liner is lubricated.
Explains symbols attached to or embossed on the machine.
Describes how instructions and procedures are marked in the manual.
Outlines key aspects for safe operation, operator, tool, and usage.
Requirements for operator's physical and mental health.
Recommendations for protective apparel for the operator.
Guidelines and warnings for safely refueling the power tool.
General information about the air filter and its maintenance.
How to properly grip and control the machine during use.
Explains the hazard of kickout and how to avoid it.
Initial steps for starting the engine, including fuel pump and choke.
Procedures for cranking the engine, including placement and grip.
How to adjust the carburetor for optimal fuel-air mixture.
How to adjust the throttle cable for correct machine operation.
General| Type | Brush cutter |
|---|---|
| Cordless | Yes |
| Head type | Blade |
| Handle type | U-type handle |
| Engine power | 2.3 hp |
| Product color | Black, Metallic, Orange |
| Uncertainty K | 2 m/s² |
| Rotational speed | 8500 RPM |
| Number of strokes | 2 |
| Sound power level | 111 dB |
| Fuel tank capacity | 0.75 L |
| Engine displacement | 37.7 cm³ |
| Sound pressure level | 98 dB |
| Cutting diameter (max) | 420 mm |
| Power source | Gasoline |
Weight and Dimensions| Length | 1800 mm |
|---|---|
| Weight | 7000 g |
