To Next PageTo Next PageWhy is the starter rope hard to pull on my Stihl Brush Cutter?
If the starter rope is difficult to pull or rewinds very slowly, the starter mechanism may be very dirty. Thoroughly clean the complete starter mechanism.
What causes a Stihl Brush Cutter gearbox to run rough and stop under load?
If the gearbox runs rough and stops running under load, the drive shaft may not fully engage. Push the gearbox onto the drive tube drive pinion assembly until the drive shaft fully engages the drive pinion.
Why is my Stihl Brush Cutter making loud noises?
Loud noises could be caused by stretched tension springs. Replace all tension springs. Alternatively, the ball bearings may be damaged or worn, in which case you should replace the ball bearings on the drive side and non-drive side.
Why is the gearbox on my Stihl Brush Cutter becoming too hot?
If the gearbox becomes too hot, it may be due to excessive friction caused by damaged or worn ball bearings. Replace the ball bearings on the drive side and non-drive side. You may also need to add gear lubricant.
Why does the drive tube assembly on my Stihl Brush Cutter get very warm?
If the drive tube assembly becomes very warm, the drive shaft may not be sufficiently lubricated. Lubricate the drive shaft along its entire length, ensuring the entire length of the flexible liner is lubricated.
Why is my Stihl Brush Cutter drive tube assembly vibrating?
If the drive tube assembly vibrates, the flexible liner may be worn, causing the drive shaft to be insufficiently supported. Replace the flexible liner.
Why doesn't the bike handle clamp on my Stihl Brush Cutter?
If the bike handle does not clamp, the clamps may be greasy or oily. Clean the clamps and bike handle.
Why can't I adjust the bike handle on my Stihl Brush Cutter anymore?
If the bike handle can no longer be adjusted, the clamps may be dirty. Clean the clamps and bike handle.
How to stop the cutting attachment rotating at idle on my Stihl Brush Cutter?
If the cutting attachment rotates at idle, the idle speed may be too high. Readjust the idle speed screw LA. If that doesn't resolve the issue, further diagnosis may be needed.
How to fix faulty tank vent on Stihl Brush Cutter?
Replace the tank vent.
General| Type | Brush cutter |
|---|---|
| Cordless | Yes |
| Head type | Blade |
| Handle type | U-type handle |
| Engine power | 2.3 hp |
| Product color | Black, Metallic, Orange |
| Uncertainty K | 2 m/s² |
| Rotational speed | 8500 RPM |
| Number of strokes | 2 |
| Sound power level | 111 dB |
| Fuel tank capacity | 0.75 L |
| Engine displacement | 37.7 cm³ |
| Sound pressure level | 98 dB |
| Cutting diameter (max) | 420 mm |
| Power source | Gasoline |
Weight and Dimensions| Length | 1800 mm |
|---|---|
| Weight | 7000 g |
Explains symbols attached to or embossed on the machine.
Describes how instructions and procedures are marked in the manual.
Outlines key aspects for safe operation, operator, tool, and usage.
Requirements for operator's physical and mental health.
Recommendations for protective apparel for the operator.
Guidelines and warnings for safely refueling the power tool.
General information about the air filter and its maintenance.
How to properly grip and control the machine during use.
Explains the hazard of kickout and how to avoid it.
Initial steps for starting the engine, including fuel pump and choke.
Procedures for cranking the engine, including placement and grip.
How to adjust the carburetor for optimal fuel-air mixture.
How to adjust the throttle cable for correct machine operation.
