To Next PageTo Next Page
Need help?Do you have a question about the Stihl FS 200 and is the answer not in the manual?
General| Engine Type | 2-stroke |
|---|---|
| Shaft Type | Straight |
| Vibration Level | 4.5 m/s² |
| Engine Power | 0.8 kW |
| Displacement (cm³) | 40.2 cm³ |
Specifies torque values for various fasteners used in assembly.
Procedures for removing and installing the clutch assembly.
Steps for removing and installing the cylinder and piston.
Steps for installing the piston and securing it with the pin.
Instructions for replacing piston rings.
Steps for removing and installing the crankshaft.
Procedures for installing the crankshaft, including bearings.
Information on the ignition module and its connections.
Procedures for removing and installing the ignition module for specific models.
Procedures for removing and installing the ignition module for specific models.
Procedures for replacing the throttle cable.
Procedures for adjusting the throttle cable.
Procedures for removing and installing the carburetor.
Procedures for removing and installing the carburetor on specific models.
Adjustment procedures for carburetors with three adjustment screws.
Adjustment procedures for carburetors with a single adjustment screw.
Instructions for removing and installing the gearhead.
Procedures for replacing the clutch drum.
