S
Sarah ShahSep 22, 2025
How to fix leak in fuel line between tank and carburetor on Stihl Brush Cutter?
- DDr. Leah Reynolds DDSSep 22, 2025
Seal connections or replace line.
To Next PageTo Next PageHow to fix leak in fuel line between tank and carburetor on Stihl Brush Cutter?
Seal connections or replace line.
What to do if metering diaphragm is deformed on Stihl Brush Cutter?
Replace metering diaphragm.
What to do if inlet needle sticking to valve seat on Stihl Brush Cutter?
Remove inlet needle, clean and refit.
How to fix diaphragm gasket leaking on Stihl Brush Cutter?
Replace diaphragm gasket.
What to do if metering diaphragm damaged or shrunk on Stihl Brush Cutter?
Replace metering diaphragm.
What to do if clutch shoes are worn on Stihl Brush Cutter?
If the clutch shoes are worn, install a new clutch.
What to do if my Stihl Brush Cutter engine runs rough and misfires?
If your Stihl Brush Cutter engine runs roughly, misfires, or experiences temporary power loss, the spark plug boot may be loose. Press the boot firmly onto the spark plug and fit a new spring if necessary.
Why won't the starter rope rewind on my Stihl Brush Cutter?
If the starter rope does not rewind, heavy fouling or rust may be present on the rewind spring. Clean or replace the rewind spring.
Why does the cutting attachment on my Stihl Brush Cutter stop under load?
If the cutting attachment stops under load at full throttle, it could be because the clutch shoes or clutch drum are badly worn. Install a new clutch or clutch drum.
Why does my Stihl Brush Cutter carburetor flood and the engine stall?
If the carburetor floods and the engine stalls, the inlet needle may not be sealing due to foreign matter in the valve seat or cone. Remove and clean the inlet needle or clean the carburetor.
General| Type | Brush cutter |
|---|---|
| Cordless | Yes |
| Head type | Blade |
| Handle type | U-type handle |
| Engine power | 2.3 hp |
| Product color | Black, Metallic, Orange |
| Uncertainty K | 2 m/s² |
| Rotational speed | 8500 RPM |
| Number of strokes | 2 |
| Sound power level | 111 dB |
| Fuel tank capacity | 0.75 L |
| Engine displacement | 37.7 cm³ |
| Sound pressure level | 98 dB |
| Cutting diameter (max) | 420 mm |
| Power source | Gasoline |
Weight and Dimensions| Length | 1800 mm |
|---|---|
| Weight | 7000 g |
Explains symbols attached to or embossed on the machine.
Describes how instructions and procedures are marked in the manual.
Outlines key aspects for safe operation, operator, tool, and usage.
Requirements for operator's physical and mental health.
Recommendations for protective apparel for the operator.
Guidelines and warnings for safely refueling the power tool.
General information about the air filter and its maintenance.
How to properly grip and control the machine during use.
Explains the hazard of kickout and how to avoid it.
Initial steps for starting the engine, including fuel pump and choke.
Procedures for cranking the engine, including placement and grip.
How to adjust the carburetor for optimal fuel-air mixture.
How to adjust the throttle cable for correct machine operation.
