To Next PageTo Next Page
Need help?Do you have a question about the Stihl FS 300 and is the answer not in the manual?
General| Engine Type | 2-stroke |
|---|---|
| Shaft Type | Straight |
| Sound Pressure Level | 98 dB(A) |
| Sound Power Level | 109 dB(A) |
| Displacement | 30.8 cc |
| Fuel Tank Volume | 0.64 l |
| Cutting Attachment | Metal blade |
Details about the STIHL single cylinder two-stroke engine.
Information on carburetor, fuel tank capacity, and mixture.
Details on the electronic magneto ignition system.
Specifications for the spiral-toothed bevel gear drive.
Lists accessories for users and service parts.
Lists fasteners and their specified tightening torques for assembly.
Procedures for removing and installing the clutch assembly.
Steps for removing and installing the clutch carrier.
How to clean or replace the muffler and spark arresting screen.
Procedures for testing engine crankcase for leaks.
How to perform pressure and vacuum tests on the engine.
Instructions for replacing oil seals on the engine.
Steps to remove the cylinder for access.
Steps to remove the cylinder and piston assembly.
Steps to install the cylinder and piston assembly.
Instructions for removing and installing piston rings.
Procedures for removing the crankshaft from the crankcase.
Steps for installing a new or original crankshaft.
How to remove and install the spark plug boot.
Procedures for removing and installing the ignition lead.
General information and connections for the ignition module.
Steps to remove and install the ignition module.
Procedures for removing and installing the flywheel.
Steps for removing and installing the short circuit wire.
General information on rewind starter operation and issues.
Instructions for replacing the rewind spring.
Steps to tension the rewind spring.
Procedures for replacing the starter rope and grip.
Steps to remove and install the throttle trigger/interlock lever.
Procedures for removing springs from the control handle.
Steps to remove and install the throttle trigger/interlock lever.
Procedures for removing and installing the slide control.
Steps for replacing the throttle cable.
Steps for adjusting the throttle cable.
Instructions for cleaning or replacing the air filter.
Steps to remove and install the carburetor.
Steps to remove and install the carburetor.
How to test the carburetor for leaks.
Adjusting the carburetor using three screws.
Adjusting the carburetor using one screw.
Information on tank vent function and cleaning pickup body.
Procedures for removing and installing fuel tank and hoses.
Steps to repair the anti-vibration system for FS 120/200.
Steps to repair the anti-vibration system for FS 300-450.
Steps to repair the anti-vibration connection for FR 350/450.
Procedures for replacing the bike handle on FS 120/200.
Procedures for replacing the bike handle on FS 300-450.
Procedures for installing loop handles with and without barrier bar.
Procedures for removing and installing the drive shaft and flexible liner.
Steps for installing a flexible shaft on FR 350/450.
Procedures for removing and installing the drive tube.
Steps to service the housing on FR 350/450.
Procedures for removing and installing the gearhead.
Steps to repair the support frame.
List of special tools with part numbers and applications.
List of servicing aids like lubricants and cleaners.
