FS 110, FS 110 R
English
30
Preparations
N Before fueling, clean the filler cap
and the area around it so that dirt
cannot fall into the tank.
N Always position the machine so that
the filler cap is facing upwards.
One of two different filler caps is
installed as standard at the factory.
Toolless filler cap (with folding grip)
Threaded filler cap
Opening the toolless filler cap
N Swing the grip into an upright
position.
N Turn the cap counterclockwise
(approx. 1/4 turn).
N Remove the filler cap.
Refueling
Take care not to spill fuel while fueling,
and do not overfill the tank. STIHL
recommends use of the STIHL filling
system (special accessory).
Closing the toolless filler cap
N Position the cap with the grip in an
upright position; the raised
positioning marks must line up.
N Turn cap clockwise as far as it will
go (approx. 1/4 turn).
N Fold the grip down so that it is flush
with the surface.
If the grip is not flush with the surface
and the lug on the clip does not engage
entirely in the recess (arrow), the cap is
not properly closed and the steps
Fueling
To Next Page
Loading...
