Stihl HSA 66 - Page 26

HSA 66
English
24
Running time is too short
Battery is not fully charged Charge the battery
Useful life of battery has been reached
or exceeded
Check battery
1)
and replace
Blades sticking / dirty Clean the blades and spray them with
STIHL resin solvent
Blades bent Have blades checked by servicing
dealer
1)
Battery jams when being inserted in power
tool / charger
Guides dirty Carefully clean the guides
Battery is not being charged even though the
light emitting diode on the charger glows
green
Battery too hot / too cold
(1 light emitting diode on battery glows
red
Allow battery to cool down / at tempera-
tures of about 59°F - 68°F (15°C - 20°C),
allow battery to warm up slowly
Operate charger only in closed, dry
rooms at ambient temperatures of 41°F -
104°F (5°C - 40°C)
Light emitting diode on charger flashes red
No electrical contact between charger
and battery
Remove the battery and refit it again
Fault in battery
(4 light emitting diodes on battery flash
red for about 5 seconds)
Take the battery out of the power tool
and refit it. Switch on the power tool – if
the light emitting diodes still flash, the
battery is faulty and must be replaced.
Fault in charger Have charger checked by servicing
dealer
1)
1)
STIHL recommends a STIHL servicing dealer.
Always remove the battery before carrying out any work on the power tool.
Condition Cause Remedy