To Next PageTo Next PageHow to fix a Stihl HLA 66 when 1 LED flashes green?
If 1 LED flashes green on your Stihl Trimmer, it indicates that the battery has a low charge. Recharge the battery fully as described in the instruction manual for the STIHL AL 101, 300, 500 chargers.
What to do if my Stihl Trimmer cuts out during operation?
If your Stihl Trimmer cuts out, it might be overheating or experiencing an electrical malfunction. First, remove the battery and allow the trimmer to cool down. If that doesn't work, remove the battery and reinsert it, then switch on the trimmer.
Why Stihl Trimmer does not start when switched on?
Your Stihl Trimmer might not start because the battery's charge is too low. To resolve this, charge the battery as detailed in the User Manual for the STIHL AL 101, 301, 301-4, 500 chargers. Another cause could be that the battery is either too warm or too cold. If this is the case, remove the battery and allow it to cool down or warm up to an acceptable temperature.
What to do if Stihl HLA 66 cuts out during operation?
If your Stihl Trimmer cuts out during operation, it may be overheating. Remove the battery and allow the trimmer to cool down. Another possible cause is an electrical fault. In this case, remove the battery and reinsert it, then switch the trimmer back on.
What to do if my Stihl HLA 66 does not start when switched on?
If your Stihl Trimmer fails to start, the issue might be a lack of electrical contact between the trimmer and the battery. To resolve this: remove the battery. Visually inspect the electrical contacts in the battery compartment and on the battery for any damage or debris. Then, reinsert the battery ensuring it clicks into place correctly.
Why is the runtime of my Stihl HLA 66 Trimmer too short?
If your Stihl Trimmer's runtime is too short, the battery may not be fully charged. Fully charge the battery as described in the User Manual for the STIHL AL 101, 301, 301-4, 500 chargers. It is also possible that the battery service life has been exceeded. In this case, replace the battery.
Why is the STIHL connected app unable to find the battery for my Stihl HLA 66 Trimmer?
If the STIHL connected app can't find the battery, ensure that the Bluetooth® radio interface is activated on both the battery and your mobile device. Also, make sure that the distance between the battery and mobile device is not excessive. Reduce the distance and try again.
What to do if 3 LEDs are flashing red on my Stihl HLA 66 Trimmer?
If 3 LEDs are flashing red on your Stihl Trimmer, it could indicate a malfunction. Remove the battery, clean the electrical contacts in the battery compartment, and reinsert the battery. Switch on the trimmer. If the issue persists, contact your STIHL dealer. Another cause could be that the cutting blades do not run freely. Spray both sides of the cutting blades with STIHL resin solvent. If the problem continues, contact your STIHL dealer.
What does it mean when 1 LED glows red on a Stihl Trimmer?
If 1 LED glows red on your Stihl Trimmer, it indicates that the battery is either too hot or too cold. Remove the battery and allow it to cool down or warm up as necessary.
What to do if 3 LEDs flash red on Stihl HLA 66 Trimmer?
If 3 LEDs are flashing red on your Stihl Trimmer, it could indicate a malfunction or that the cutting blades aren't running freely. Remove the battery, clean the contacts, and reinsert the battery. If the issue continues, spray the blades with STIHL resin solvent. If the problem persists, do not use the hedge trimmer and contact your STIHL dealer for assistance.
General| Battery Type | Lithium-Ion |
|---|---|
| Power source | Battery |
| Battery voltage | 36 V |
| Vibration level left/right | 2.5/2.5 m/s² |
| Blade Length | 20 inches |
| Stroke Rate | 3, 000 spm |
Specific safety warnings tailored for hedge trimmer operation and extended reach models.
Specifies the necessary personal protective equipment for safe operation.
Details safe practices for operating the hedge trimmer, including handling and conditions.
Lists important warnings and instructions for safe battery handling and usage.
Outlines the specific preparations required for the hedge trimmer before use.
Step-by-step guide for correctly inserting the battery into the tool.
Step-by-step guide for safely removing the battery from the tool.
Details the steps required to safely start and stop the hedge trimmer.
Instructions for adjusting the cutting blade angle for optimal use.
Explains how to adjust the drive tube length on the HLA 86 model.
Detailed instructions on how to use the hedge trimmer in various cutting scenarios.
Covers inspection and maintenance procedures for the hedge trimmer unit.
Details inspection and maintenance for the cutting blades.
