Stihl MS362C-M User Manual

MS 362 C-M
English
40
If there is a noticeable loss of engine
power
N Remove the shroud – see "Shroud".
Removing the air filter
N Clean away loose dirt from around
the filter.
NOTICE
To avoid damaging the filter, do not use
tools for removing and installing the air
filter.
N Rotate the air filter a 1/4 turn
counterclockwise and lift it away in
the direction of the rear handle.
N Always replace damaged filters.
Cleaning the air filter
N Wash the filter in STIHL special
cleaner (special accessory) or a
clean, non-flammable solution (e.g.
warm soapy water). Rinse the filter
from the inside outwards under a jet
of water – do not use a pressure
washer.
N Dry the filter components – do not
expose to high temperatures.
N Do not impregnate the filter with oil.
N Reinstall the air filter.
Installing the air filter
N Place the air filter in position.
N Push the air filter in the direction of
the filter housing and turn it
clockwise at the same time until it
engages – the "STIHL" name must
be horizontal.
N Install the shroud – see "Shroud".
Exhaust emissions are controlled by the
design of the fundamental engine
parameters and components (e.g.
carburation, ignition, timing and valve or
port timing) without the addition of any
major hardware.
Cleaning the Air Filter
1.
5902BA010 KN
2.
5902BA011 KN
2.
1.
Engine Management

Stihl MS362C-M Specifications

General

Engine Power	3.5 kW
STIHL M-Tronic	Yes
Chain Pitch	3/8"
Weight	5.9 kg
Guide Bar Length	40-50 cm
Displacement	59 cm³