Stihl MS362C-M User Manual

MS 362 C-M
English
42
Checking the Spark Plug
N Clean dirty spark plug.
N Check electrode gap (A) and
readjust if necessary – see
"Specifications."
N Use only resistor type spark plugs of
the approved range.
Rectify problems that have caused
fouling of spark plug:
– too much oil in fuel mix,
– dirty air filter,
– unfavorable running conditions, e.g.
operating at part load.
WARNING
To reduce the risk of fire and burn injury,
use only spark plugs authorized by
STIHL. Always press spark plug boot (1)
snugly onto spark plug terminal (2) of the
proper size. (Note: If terminal has
detachable SAE adapter nut, it must be
securely attached.) A loose connection
between spark plug boot and ignition
wire connector in the boot may create
arcing that could ignite combustible
fumes and cause a fire.
Installing the Spark Plug
N Screw home the spark plug, fit the
boot and press it down firmly.
N Fit the shroud.
000BA039 KN
A
1
2
000BA071 KN
4903BA008 KN

Stihl MS362C-M Specifications

General

Engine Power	3.5 kW
STIHL M-Tronic	Yes
Chain Pitch	3/8"
Weight	5.9 kg
Guide Bar Length	40-50 cm
Displacement	59 cm³