SE 122
English
12
When dry-vacuuming with filter bag
N Pull filter bag sleeve (1) off intake
port and seal opening in filter bag
sleeve with slide (2)
N Carefully remove filter bag from
container and dispose of in
accordance with statutory
regulations
N Insert new filter bag (3) (instructions
on filter bag)
N Push filter bag sleeve onto intake
port as far as possible
Refit the upper part of the vacuum
cleaner
N Clean the edge of the container
N Refit the upper part of the vacuum
cleaner
N Clean the sleeve and intake port
before fitting the suction hose
N Squeeze sleeve (1) of suction hose
(arrows) together to release it
N Remove suction hose
N Switch on machine
N Seal the hose at the sleeve by firmly
pressing the sleeve against the flat
surface beside the switch (as shown
in picture)
N Press the filter cleaning button 3
times
Dust deposits are removed from the filter
element.
N Unplug the power plug from the
socket
N Remove upper part of vacuum
cleaner and turn it over
N Unscrew supporting cage for
filter (1)
N Remove filter element (2) and
dispose of it in accordance with the
statutory regulations
N Fit new filter element in the reverse
sequence of steps
N Check correct operation of the float:
the float must move easily when the
supporting cage for the filter is
turned over.
N Refit upper part of the vacuum
cleaner
Cleaning the filter element
Replacing the filter element
To Next Page
Loading...
