Adjust carrying harness to suit your size
before starting work.
)XHOLQJ
This STIHL unit uses an oil-gasoline
mixture for fuel (see the chapter on
"Fuel" of your owner‘s manual).
:DUQLQJ
Gasoline is an extremely
flammable fuel. If spilled
or ignited by a spark or
other ignition source,
it can cause fire and
serious burn injury or property damage.
Use extreme caution when handling
gasoline or fuel mix.
Do not smoke or bring any fire or flame
near the fuel.
)XHOLQJLQVWUXFWLRQV
Fuel your machine in well-ventilated
areas, outdoors only. Always shut off the
engine and allow it to cool before
refueling. Relieve fuel tank pressure by
loosening fuel cap slowly. Never remove
fuel filler cap while engine is running.
Select bare ground for fueling and move
at least 10 feet (3 m) from the fueling
spot before starting the engine. Wipe
off any spilled fuel before starting your
mistblower and check for leakage.
Always tighten fuel filler cap securely
after fueling.
:DUQLQJ
To reduce the risk of serious injury from
burns, never attempt to refuel the unit
until it has been completely removed
from the operator.
:DUQLQJ
Check for fuel leakage while refueling
and during operation. If fuel or oil
leakage is found, do not start or run the
engine until leak is fixed and spilled fuel
has been wiped away. Take care not to
get fuel on your clothing. If this happens,
change your clothing immediately.
Always store gasoline in approved
container.
:DUQLQJ
Unit vibrations can cause an improperly
tightened fuel cap to loosen or come off
and spill quantities of fuel.
In order to reduce risk of
fuel spillage and fire,
tighten fuel cap by hand
with as much force as
possible.
6WDUWLQJ
You should always inspect your unit
before starting it. Make sure the controls
and safety devices are working properly.
:DUQLQJ
Your mistblower is a one-person
machine. To reduce the risk of eye or
other injury from thrown objects, insure
that bystanders are at least 50 feet (15m)
away during use.
Stop the engine immediately if you are
approached.
The assistance of another person may
be needed in placing the unit on your
back after starting. In order to reduce the
risk of injury to the assistant from thrown
objects or from contact with fumes, the
engine should be kept at idle speed
during this brief period, and your
assistant should not stand in the area of
the outlet nozzle or exhaust. Otherwise,
To Next Page
Loading...
Need help?
General
