Stika SV-15 User Manual

USER'S MANUAL
Thank you very much for purchasing this product.
➢ To ensure correct and safe usage with a full understanding of this product's performance, please be
sure to read through this manual completely and store it in a safe location.
➢ Unauthorized copying or transferral, in whole or in part, of this manual is prohibited.
➢ The contents of this operation manual and the specifications of this product are subject to change
without notice.
➢ The operation manual and the product have been prepared and tested as much as possible. If you
find any misprint or error, please inform us.
➢ Roland DG Corp. assumes no responsibility for any direct or indirect loss or damage which may
occur through use of this product, regardless of any failure to perform on the part of this product.
➢ Roland DG Corp. assumes no responsibility for any direct or indirect loss or damage which may
occur with respect to any article made using this product.

Stika SV-15 Specifications

General

Brand	Stika
Model	SV-15
Category	Cutter
Language	English

Summary

Read This First

Safety Precautions

Provides essential safety guidelines and important notes for operating the machine.

! To Ensure Safe Use

Operational Safety Guidelines

Specific warnings and precautions for safe machine operation and installation.

Electrical Hazard Warnings

Details critical safety measures to prevent electrical shocks, shorts, and fires.

Power Cord Safety

Provides visual guidance on safe handling and connection of power cords and outlets.

Important Notes on Handling and Use

Chapter 1: Setup Preparation

Installation Site Selection & Space

Details requirements for a suitable installation location and necessary clearance around the machine.

Connecting Cables and USB

Guides on connecting power and USB cables, including notes on USB hub usage.

Chapter 2: Installing Software

Windows System Requirements

Details the necessary system configurations for USB connection, CutStudio, and STIKA driver on Windows.

Installing the STIKA Driver

A step-by-step guide for installing the essential STIKA driver software on Windows.

Installing Roland CutStudio

Macintosh System Requirements & Software Installation

Chapter 3: Performing Cutting

Step 1: Load Material

Step 2: Create Cutting Data

Step 3: Perform Cutting

Chapter 4: Mastering the STIKA

Checking Cutting Quality

Adjusting Blade Extension Amount

Detailed steps for adjusting the blade extension for precise cutting.

Chapter 5: Maintenance

Routine Maintenance Tasks

Replacing the Cutting Blade

Step-by-step guide for safely replacing the worn or damaged cutting blade.

Replacing the Blade Protector

Chapter 6: Appendix

Troubleshooting: Machine Issues

Steps for resolving problems like the machine not running or cuts being unclean.

Troubleshooting: Cut Location Shifts

Steps for diagnosing and fixing issues with the cut location shifting or incisions being uneven.

Troubleshooting: Material Shifting & Driver Install

Addresses problems with material shifting during cutting and driver installation failures.

Uninstalling the STIKA Driver

Shaft Lubrication Procedure

Product Specifications Summary