What to do if I feel no stimulation from my Stim Wave Technologies PDBT-915-2K?
If you do not feel stimulation from your Stim Wave Technologies Antenna, first, ensure the device is powered on. If it is, turn the power OFF, wait 5 seconds, and then turn it back ON. Also, make sure the antenna is directly over the implanted Stimulator. If the amplitude is set too low, increase it until you feel the stimulation.
How to fix an unresponsive Stim Wave Technologies PDBT-915-2K Antenna?
If the indicator light on your Stim Wave Technologies Antenna doesn't turn on or the stimulation amplitude keys are unresponsive, try the following: First, ensure the device is powered ON. If the system seems frozen, turn the power OFF, wait 5 seconds, and then turn it back ON. If neither of these steps works, the battery may be discharged. Recharge the battery by connecting the antenna to the charger.
Why is my Stim Wave Technologies PDBT-915-2K heating up?
If your Stim Wave Technologies Antenna is heating up during operation, ensure it is well-ventilated. Avoid placing it directly on your skin or covering it with clothing. The WAA will heat up during heavy operation, just like your cell phone will be warm during heavy usage. If the temperature becomes uncomfortable, stop using it, remove it from your body, and contact your clinician.
What to do if my Stim Wave Technologies PDBT-915-2K Antenna stimulation is intermittent?
If you experience intermittent stimulation from your Stim Wave Technologies Antenna, ensure the antenna is placed directly over the implanted Stimulator, as a poor connection may be the cause. If you are still not receiving adequate pain relief, contact your clinician or Stimwave.
What to do if fluid gets on my Stim Wave Technologies PDBT-915-2K?
If you spill fluid on your Stim Wave Technologies Antenna or drop it in water, immediately remove it from the water. Then, dry it with a towel damped with clean tap water. Unplug the power cord and allow the device to air dry at room temperature for 24-48 hours. Remember that the WAA is not waterproof, and water can damage it.
What to do if I dropped my Stim Wave Technologies PDBT-915-2K?
If you drop your Stim Wave Technologies Antenna, try powering it ON and allow it to transmit for 10 minutes while not worn on the body. On its next charge cycle, monitor the WAA’s temperature while it is charging to prevent the battery from getting too hot. If the WAA seems to be heating up excessively while charging, then unplug the charging cable from the WAA and let it sit in a well-ventilated area for a few minutes to cool down. Also, contact your clinician.
How to reduce uncomfortable stimulation from Stim Wave Technologies PDBT-915-2K Antenna?
If you are too uncomfortable with the stimulation from your Stim Wave Technologies Antenna, it may be because the selected parameter settings are not suitable for your activity or posture. Reduce the amplitude of the WAA. If that doesn't work, remove the WAA from your body.
Есть ли в Москве фирма по ремонту данных нейростимуляторов?
General| Brand | Stim Wave Technologies |
|---|---|
| Model | PDBT-915-2K |
| Category | Antenna |
| Language | English |
To Next Page