www.stingerworld.com
CS150 Cap Stapler
OPERATING(THE(TOOL(
11. Cycle the tool on a scrap work piece to evaluate the depth of penetration by the fastener into
the work piece.
12. To adjust the depth of penetration, regulate the air pressure at the regulator and/or
disconnect the air hose, adjust the depth control screw, connect the air hose, and cycle the
tool on a scrap work piece to evaluate the adjustment.
13. Repeat Step 12 as needed to set the correct depth, using the minimum amount of air
pressure to drive the fastener.
7
To Next Page
Loading...
