4
IMPORTANT PRECAUTIONS – continued
ASSEMBLY INSTRUCTIONS
Step 1
Connect the high pressure hose to the
unit’s high pressure outlet.
Step 3
Insert the spray wand of your choice into
the trigger gun. Press in against the spring
tension and twist into the locked position.
Step 2
Connect garden hose to unit’s water inlet
Water Supply (Cold Water
Only)
• Water hose must be at least 3/4 inch in
diameter.
• Flow rate of water supply must not fall
below 2 GPM (gallons per minute).
• Flow rate can be determined by running
the water for one minute into an empty
5-gallon container.
• The water supply temperature must not
exceed 104°F/40°C.
• Never use the pressure washer to draw
in water contaminated with solvents, e.g.
paint thinners, gasoline, oil, etc.
NOTE: Dirt in the feed water will
damage the unit. To avoid this risk,
we recommend fitting a water filter.
• Always prevent debris from being drawn
into the unit by using a clean water source
and an accessory water filter if required.
To Next Page
Loading...