To Next PageTo Next Page
Need help?Do you have a question about the Stock DISOCONT Tersus DT-9 and is the answer not in the manual?
General| Power Supply | 115/230 VAC +10% -15%, 50/60 Hz, 25 VA |
|---|---|
| Operating Temperature | -10 °C to +50 °C |
| Outputs | Current (0-20mA, 4-20mA) |
| Communication | RS-485 |
| Display | LED |
| Measurement Range | 9999 |
Precautions for handling electronic components sensitive to static discharge.
Introduces the DISOCONT Tersus as a versatile weighing and feeding electronics family.
Outlines the procedure to verify feeder and control operations.
Explains how parameters tailor the controller to specific needs.
Details the calibration process for the feeder.
Guides on adjusting analog input/output signals for accurate control.
Describes the initial login and setup for the HMI.
Provides step-by-step procedures for typical feeder operations.
Describes EasyServe as a PC program for commissioning, servicing, and operations.
Guides on starting EasyServe and establishing a connection to the feeder.
Explains performing a material test for accurate accuracy determination and correction.
