Why is my Stoelting Freezer rear auger seal leaking?
A rear auger seal leak can occur if the rear auger seal is not lubricated, the seal or O-ring is missing or installed incorrectly, or the shaft is worn or scratched. Try lubricating the seal. Check the seal or O-ring. If the shaft is worn or scratched, replace it.
Why is the mix temperature too cold in my Stoelting Freezer cab?
The mix temperature may be too cold because the temperature control is set too cold. Contact your local Stoelting Distributor.
Why is the mix temperature too warm in my Stoelting Freezer cab?
The mix temperature may be too warm because the system is low on refrigerant or the temperature control is set too warm. Add refrigerant. For the temperature control, contact your local Stoelting Distributor.
What to do if I get a Cab Sensor error (Error Code 08) on my Stoelting Freezer?
To address a Cab Sensor error, place the Freezing Cylinder Off-On Switch in the Off position, wait 10 seconds, and return the switch to the On position.
What to do if I get a Drive Motor Current error (Error Code 07) on my Stoelting Freezer?
To address a Drive Motor Current error, place the Freezing Cylinder Off-On Switch in the Off position, wait 10 seconds, and return the switch to the On position.
What to do if I get a Freezing Cylinder Sensor error (Error Code 05) on my Stoelting Freezer?
To address a Freezing Cylinder Sensor error, place the Freezing Cylinder Off-On Switch in the Off position, wait 10 seconds, and return the switch to the On position.
What to do if I get a Clean Error (Error 04) on my Stoelting Freezer?
To address a Clean Error, place the Freezing Cylinder Off-On Switch in the Off position, wait 10 seconds, and return the switch to the On position.
What to do if I get a program board error (Error Code 01) on my Stoelting Freezer?
To address a program board error, place the Freezing Cylinder Off-On Switch in the Off position, wait 10 seconds, and return the switch to the On position.
Why is my Stoelting Freezer spigot leaking?
A leaking spigot can be caused by spigot parts not being lubricated, chipped or worn O-rings, O-rings on the spigot being installed incorrectly, or nicks or scratches on the front door where the spigot is located. Try lubricating the spigot parts. Replace any chipped or worn O-rings. Remove the spigot and check the O-rings for proper installation. If there are nicks or scratches on the front door, replace the front door.
Why does my Stoelting Freezer compressor not operate?
The compressor might not be operating due to several reasons: the power to the freezer is off; the drive motor is overloaded; there's low line voltage; the compressor's internal overload is cut-out; or the front door isn't securely installed. To address this, check the power supply to the freezer. Allow 15-20 minutes for the thermal overload to reset. Verify the line voltage is within +/-10% of the nameplate voltage. Inspect the condenser and clean the air filter. Ensure the front door is securely installed.
Lists essential safety rules for operating the Stoelting freezer, emphasizing awareness and proper procedures.
Covers important information regarding soil materials, cleaning vs. sanitizing, and proper daily maintenance for food safety.
Recommended operating procedures for initial freeze down, including mix preparation and system startup.
Guides on adjusting product consistency and overrun settings to achieve desired product quality.
Covers preventative maintenance schedules, error codes, and troubleshooting common freezer problems.
General| Brand | Stoelting |
|---|---|
| Model | F431 |
| Category | Ice Cream Maker |
| Language | English |
To Next Page
