- 15 -
Introduction
STANDARD FEATURES
Your new CF Power Trowel comes standard
with many features to enhance productivity,
performance and safety. Listed below are just a
few of these features.
DYNA-CLUTCH--Patented safety device
automatically stops blade rotation without
shutting down the engine, if the trowel gets
away from the operator. Prevents injury to
personnel and damage to the trowel and
fresh concrete surfaces.
ADJUSTABLE THROTTLE--
Located in a
convenient location, this push-pull throttle
control can be set to provide any desired blade
speed and located in place at the desired
operating speed.
BENT ARM ADJUSTMENT--Allows
blades to be adjusted to compensate for bent
arms caused by dropping or mishandling the
trowel. Can be easily adjusted on-site for
consistent finishing.
HEAVY DUTY RING GUARD--Protects
operator and unit while providing lower
center of gravity which contributes to unit
stability and performance.
CAST IRON SPIDER--Extra strong, houses
a double set of replaceable nylon bearings for
each blade arm to insure alignment and elimi-
nate seizing. Also contributes to lower center
of gravity for increased trowel performance.
ADJUSTABLE HANDLE--Can be posi-
tioned to provide comfort and control for any
operator's height. Equipped with flanged and
cushioned motorcycle style hand grips to
absorb vibration and minimize operator fatigue.
Standard Features/Preparation
for Service
PREPARATION FOR SERVICE
BEFORE STARTING--Your new CF Power
Trowel has been assembled and tested at the
factory. However, before placing the unit into
service the following items should be checked:
ASSEMBLY AND HARDWARE--The unit
is shipped completely assembled, except for
installation of the adjustable handle. Consult
the HANDLE ASSEMBLY exploded diagram
and assemble the adjustable to the main handle
with handle adjustment knob as shown.
Next check all hardware on the unit and engine.
Consult the HARDWARE AND TORQUE
CHART section of this manual for general
guidelines and recommendations and tighten any
suspicious hardware.
OIL LEVEL AND LUBRICATION--
Check the oil level in the engine and gearbox.
Engine and trowel warranties are VOID if this
unit is run without oil. Also, check the blade
arms and thrust bearing to make sure they have
been greased. Consult the LUBRICATION
SPECIFICATION SECTION of this manual for
lubrication requirements and instruction, if
required.
FUEL--Fill the fuel tank on gasoline engines
with clean gasoline from a safety can. DO NOT
mix oil with the gasoline.
FOLLOW SAFETY PRECAUTIONS
WARNING
To Next Page
Loading...
