MAINTENANCE
- 18 -
Daily Continued/Service
Check List
Clean the water reservoir pan at least once a day—
twice a day in heavy cutting—and refill with clean
water. Run clean water through your saw at the end
of each day to extend the life of pumps and other
components.
Grease blade shaft bearings daily.
Never transport a masonry saw with the cutting head
in position on the frame. The severe pounding and
bouncing can knock the head out of alignment.
ALL SAWS
• All gas saws set Engine RPM at 3600 +0 / -100
(no load).
• Check blade clamp hub face run-out with
indicator and magnetic chuck. Run-out not to
exceed .015”.
• Check belt tension:
• MS1 Electric & Gas Belt deflection = .21
inches at 2.5 lbs. for used belt and 3.0 lbs for
new belt.
• MS2 Electric & Gas Belt deflection = .19
inches at 3.5 lbs. for used belt and 4.5 lbs for
new belt.
• Grease all pillow blocks.
• All guards in place, all hardware tight.
• Apply Never-Seize to acme screw.
• Check cutting tables wheels are tight and
rotating.
• Belts and pulleys in line.
• On gas units make sure kill switch is functional
while running.
• Disconnect spark plug or unplug unit when
servicing unit.
To Next Page
Loading...
