• Plug your heater in the receptacle labeled HEATING on the INKBIRD plug in cord.
DO NOT plug your CoolBot or your A/C in the socket labeled COOLING of the
INKBIRD. Leave that one empty!
• Turn your heater ON and set the Heat level to Low.
NOTE: Heaters are very efficient. A small heater can handle large rooms. As a general
rule, you need a heater that has (Area X 10) in watts power. For example, a 100 sq. ft
room would require a 1000W heater. If your heater is a 1200W or a 1500W, run your
heater on Medium or Low (DO NOT RUN ON HIGH as the INKBIRD cord won’t be
able to handle the load of the Heater).
To Next Page
Loading...
