INSTALLATION
NOTE: BLAT Modular must be mounted to a wall stud to achieve the advertised weight limit
1
2
3
4
Installing Backplate cont.
• Use a level to ensure the backplate is parallel to the ground.
• Mate the smaller radius of the Aluminum Washer (B) to the semi-circular cutout in the
backplate and mark the center hole with a pencil.
• Using a 3/16” drill bit, make a pilot hole at the center hole mark.
• Using a Lag Screw (C) and Washer (D), secure the Aluminum Washer (B) to the Backplate
until snug.
4
Installing the remaining Backplates.
• Back off the Lag Screw (C) and slide the Backplate (A) underneath the Aluminum
Washer (B) like in Step 2.
• Re-Tighten and repeat Step 3 and Step 4 for any additional Backplates (A).
5
6
Tips & Maintenance
• This system works off 16” stud spacing. If your studs are spaced at a different width, you
can screw a 2” x 4” into the studs and mount this system onto the face of the 2” x 4”.
• Periodically check the tightness of the lag screws. Re-tighten if necessary.
• An Attachment can be placed over the center stiffening joints.
Installing Attachments
• Back off the Thumbscrew (E).
• Line up the slot in the Attachment (F) with the top bar on the Backplate (A).
• Slide the Attachment (F) down and tighten the Thumbscrew (E).
• For fine positioning, slightly loosen the thumbscrew, position the attachment, and
retighten.
Back View
To Previous Page
Loading...