EasyManua.ls Logo

STOVES 900G - Installation Instructions

STOVES 900G
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INSTALLATION INSTRUCTIONS
Before you start:
Please read the instructions, planing your
installation will save you time and effort.
Check that your appliance is suitable for
the gas supply in your house - ie; Natural
Gas only. This is clearly marked on the
data badge.
The appliance must be installed (and
serviced) by a Corgi registered approved
installer or a person competent to ensure
that the installation is in accordance with
“The Gas Safety (Installation & Use)
Regulations 1994”, & the “The Gas
Safety (Installation & Use) (Amendment)
Regulations 1996”. Failure to comply with
these Regulations is a criminal offence.
Where regulations or standards have been
revised since this handbook was printed,
always use the latest edition.
In the UK the regulations and
standards are as follows:
1. Gas Safety Regulations 1996
(Installation and Use).
2. Building Regulations - Issued by the
Department of the Environment.
3. Building Standards (Scotland)
(Consolidated) - Issued by the Scottish
Development Department.
4. The current I.E.E. Wiring Regulations.
5. Electricity at Work Regulations 1989.
6. BS 6172 Installation of Domestic Gas
cooking Appliances
7. Installation & Servicing Instructions for
this appliance.
Ventilation Requirements
The room containing the appliance should
have an air supply in accordance with
BS 5440: Part 2: 1989:
All rooms require an openable window,
or equivalent, and some rooms will
require a permanent vent as well.
For room volumes up to 5 m
3
an air
vent of 100 cm
2
is required.
If the room has a door that opens
directly to the outside, or the room
exceeds 10 m
3
NO AIR VENT is
required.
For room volumes between 5 m
3
and
10 m
3
an air vent of 50 cm
2
is
required.
If there are other fuel burning
appliances in the same room, BS
5440: Part 2: 1989 should be
consulted to determine the air vent
requirements.
This appliance must not be installed in
a bed sitting room of less than 20 m
3
or in a bathroom or shower room.
Windows and permanent vents should
therefore not be blocked or removed without
first consulting a CORGI gas installer.
Failure to install appliances correctly
is dangerous and could lead to
prosecution.
27
23894 02 - Q901G/900G RS2 03/04/2001 14:19 Page 29

Related product manuals